Finisher Unit Installation Guide
Components
Step 1: Prepare the Printer
1. Turn the printer off (
!
) and disconnect the
power cord ( ) and interface cable (
"
#
).
2. Using a screwdriver, remove the breakout
panels on the side of the printer.
1
2
3
4
5
6
Finisher Unit
Finisher stand
Finisher Stacker
Finisher Cover
Power Cord
7
8
9
Inverter Stand
Clear Band
Band Stopper, Small
10 Band Stopper, Large
11 Metal Brackets
12 Cable (inverter to printer)
Inverter Unit
Not illustrated: Screws
2. Remove the two bottom caps:
a. Turn the inverter over.
3. Turn the inverter around and remove the
screws holding the metal brackets in place.
Keep the screws and brackets handy: they are
used to help secure the extension plate once it
is repositioned.
b. Remove the two screws securing the bottom
caps on either side of the inverter.
4. Turn the inverter around and remove the
two screws holding the extension plate.
Keep them handy to reattach the plate once
it is repositioned.
c. Remove the end caps and store them along
with the four screws in case you ever need
to convert the unit back.
3
|